"The reason cleaning is
so important is that our machine pulls much acid from the body. During the
treatment that acid becomes baked on the array plates. If it is not removed
through proper cleaning, it will oxidize the stainless steel as the array sits
in the air between treatments.
"While
stainless steel is corrosion RESISTANT (not corrosion proof), acid will eat
through the metal and substantially decrease its life span. Cleaners such
as vinegar do NOT remove the acid from the array, as vinegar itself is an acid.(Think back to the “volcano” science experiments many of us did in
school, using baking soda and vinegar.) Only cleaners such as CLR or
Lime-Away will remove the acid and mineral build-up from arrays after a
treatment, which limits rusting/oxidation."
-- Ionic Body Balancer User Manual, page 12
For
demonstration purposes, we are using a new array.
You will
probably want to rinse your array in tap water before cleaning.
Detox material WILL stain carpet, and is likely to make linoleum
flooring VERY slippery!
You may
also want to wrap the array (steel portion only) in an old rag
to prevent drips. You can use the same rag you used to wipe off
your feet after a treatment, if you'd like.
(Please note the absence of old toothbrushes, rags, vinegar,
toothpaste, toothpicks, Q-tips, etc. from the photo above.
You do not need them!)
1. You
will need a re-useable food storage container with lid
(approximately 40 oz.- ours is 32 oz.), and a bottle of
mineral/lime removing cleaner (approximately 12-15 oz.).
Below are
several cleaners that we recommend for use with our array.
Bottle designs may vary by region. We neither own any rights
to, nor profit from the purchase of these products.
CLR
(any variety is fine)
Lime-A-Way
The Works***
(***DO NOT
USE 'THE WORKS TOILET BOWL CLEANER' ON ARRAYS-
ARRAYS WILL DISINTEGRATE!! ONLY USE TUB AND
SHOWER CLEANER!)
2. Empty
your bottle of cleaner into the food container.
3. Fill
the rest of the container with water (tap water is fine!).
4.
Place the array into the food container. (Please note:
there is not any part of the cable, or the light-blue cable
connectors touching the cleaning solution. Our cables are
NOT designed to be submerged under water. They WILL rust!)
5. If
needed, add more water until the top of the steel bars are
submerged. Let the array soak in this solution for about 10
minutes.
6.
Rinse the array in tap water, and put the lid on your food
container, for future use. You can use the same cleaning
solution over and over again! Your array is clean, and ready
to go for your next treatment! For future cleanings, you
need only repeat steps 4-6.
Best Wishes and Great Health!
Casas Adobes
Design
Copyright 2002-2010 Ionic Body Balancer All
Rights Reserved.
